Mesh Copier is a handy tool for copying mesh details from one place to another place.

The source can be defined by selected edge ring or face, and the destination is defined by selected faces.

There are two ways to use the tool :

Method 1 : Use Edge Ring as source and paste to faces

Select the edges around your details. The edges must be a closed loop. Run the tool, then select “Set Source”

Select the target faces, then run the tool again and select “Paste”

Select the edge loop around the details :

Run the tool, it will select the region of details. If the region is not correct, you can change it in Left-Bottom menu

Select the target faces :

Run the tool again. It will paste the copied details onto the faces. You can change the orientation and other settings in the Left Bottom menu.

You can use this tool to create complex model with duplicated parts easily !

Method 2 : Use Face as source, and also copy some separated meshes, then paste to target faces.

Select a face then run the tool, select Set as Source

Select the additional meshes (separated mesh) and also select the source face, then run the tool, and select Copy mesh

Select target faces then run the tool and select Paste

Limitations
Does not support curved surface for source. The source edge ring needed to be on flat surface

Update
Version 2.0.0

Simplified the workflow and make it easier to use !

Now you can copy separated mesh directly in the Left-bottom Menu ! No need to hold shift/ctrl keys anymore !

Select Copy or Paste in the left-bottom menu ! 

Downloads: pls buy & support the dev!

IF THE LINKS ARENT WORKING, THEN PLEASE ACT LIKE A GROWN UP AND MESSAGE ME/ COMMENT HERE OR ON DISCORD AND I WILL UPDATE THESE LINKS QUICKLY!

Filename:mesh_copier_2.0.0 vfxmed.zip

Official Discord : https://discord.gg/M2kqB4M9tG

Recommended link below => FULL SPEED.

https://www.file-upload.com/kbnq7fruytca

MIRRORS:

for mega and g drive links – contact admin.